free site templates

CONTROL PANEL UNIT

FOR HOT FOIL STAMPING MACHINES

This is the real Control Part of the attachment. It comprises of two major divisions; a.) Motor Controller - it has a CPU, a Stepper Drive, a Power Supply and a user friendly keyboard with display. b.) Temperature Controller - this controls the temperature of the heater plate. It has as PID type temperature controller and a 3 phase solid state relay card to drive the power of the heater plate. The following are the parts of the Control Panel Unit:    

  1. High Voltage Power Supply- This part is located in the left most slot of the mother board. It has a Red colored LED (light) on this. The light glows when the power is , switched ON. Output voltage of this card is 55 volts and 70 volts D.C.
  2. Low Voltage Power Supply- This is inserted in the 2nd slot of the mother board. It has a green colored LED on it. Output voltages of this part are -5v, 15 v,5v D.C.
  3. CPU- This card contains the micro controller, which is responsibie for the total, control. It has a gray colored flat cable, 'which goes to the keyboard and display. Location of this part is third slot on the motherboard.
  4. Stepper Drive- This part supplies power to the stepper motor. Its location is fourth slot of the motherboard. Failure of this card results in power failure of the motor.
  5. Temperature Controller- This device is Em advanced temp. Controlier with PID control technique. It controls the temperature of the heater plate.
  6. Solid State Contactor- It is mounted on an insertable card. Its location is in the fifth slot of the motherboard.
  7. Keyboard & Display- This is mounted on the front plate of the control panel. It is used to feed and see the variables of the foil pulling.
  8. MCB- It is located on the left wall of the control panel. It is used to disconnect the three phase power of trreheater plate.
  9. Motherboard- This holds all the electronic cards and connects them to each other as well as the external devices.
  10. Connectors

ARE YOU LOOKING FOR HOT FOIL STAMPING ATTACHMENT SOLUTION?

SEND US YOUR REQUIREMENT HERE >

CONTACT

SUBSCRIBE

Get monthly updates about our new products.

© Copyright 2019 Precise Equipments - All Rights Reserved.
Website kreated by KNACK